Model Number

0086-13417300945

The Tech-2 is the same tester GM Technicians use to diagnose GM vehicles. The Vetronix Tech 2 comes with Authentic GM software and provides support for on-board diagnostics on all GM systems 1992 thru 2008

Features:

• Authentic GM software in the Tech 2 Flash means the most comprehensive diagnostic software available for late model GM vehicles.
• Support for on-board diagnostics on all GM systems 1992 thru current year.
• Removable hardware modules provide insurance against scan tool obsolescence.
• Large, easy-to-read backlit screen.
• RS232 & RS485 ports provide the avenue to connect future devices to your Tech 2 Flash.
• Ability to capture stored DTCs, Freeze Frame, and Failure Record for later review.
• Ability to view the status of vehicle diagnostic tests as they run.

Bi-directional
The authentic GM 1992-current year software will provide full bi-directional control when performing power train, chassis, and body diagnostics.

Vetronix Tech 2 Specifications

Dimensions	12″×6″×2″
Microprocessor	32 bit, 16 MHz
Memory	32 MB flash type II PCMCIA. Type III slot available for future expansion.
Communications	Integral RS232 communication port.
Screen	3.8″×2.8″ backlit monochrome with full graphics capability: 320×240 pixels. Displays up to 9 vehicle parameters at once

Download Tech2 Brochure ( 5.2 Mb )

GM Tech-2 Starter Kit with Candi Module & TIS Kit includes (All ORIGINAL and NEW!):

• Tech-2 Flash Tester
• 32 MB PCMCIA Card with GM OE Applications
• CAN diagnostic interface module(CANdi) and instruction sheet download ( 199.2 kb )
• GM aftermarket Expertec TIS software on DVD-ROM disks
• TIS2000 dongle to access SPS/Security features
• Data/Sensor/Trouble Code Manual
• DLC Cable, DLC Loopback Adapter
• 12V Cigarette Lighter Power Cable
• SAE 16/19 Adapter
• NAO 12/19 Adapter
• Battery Power Cable
• Storage Case
• Tech-2 Users Manual download ( 3.9 Mb )

An industry change in protocol from OBD II to Controller Area Network (CAN) has begun. In order to perform diagnostics on a vehicle that uses the CAN interface; you will need the Tech 2 Flash and a CAN diagnostic interface module. The module connects between the Tech 2 Flash¡¯s diagnostic link cable and the OBD adapter. Once the module is connected, it can be used on all GM vehicle applications, even those vehicles using other platforms such as OBD I and OBD II.